#
# Block device driver configuration
#
mainmenu_option next_comment
comment 'Block devices'

tristate 'Normal PC floppy disk support' CONFIG_BLK_DEV_FD
if [ "$CONFIG_AMIGA" = "y" ]; then
   tristate 'Amiga floppy support' CONFIG_AMIGA_FLOPPY
fi
if [ "$CONFIG_ATARI" = "y" ]; then
   tristate 'Atari floppy support' CONFIG_ATARI_FLOPPY
fi
if [ "$CONFIG_MAC" = "y" ]; then
   if [ "$CONFIG_EXPERIMENTAL" = "y" ]; then
      bool 'Macintosh IIfx/Quadra 900/Quadra 950 floppy support (EXPERIMENTAL)' CONFIG_BLK_DEV_SWIM_IOP
   fi
fi
if [ "$CONFIG_MCA" = "y" ]; then
   tristate 'PS/2 ESDI hard disk support' CONFIG_BLK_DEV_PS2
fi
if [ "$CONFIG_ZORRO" = "y" ]; then
   tristate 'Amiga Zorro II ramdisk support' CONFIG_AMIGA_Z2RAM
fi
if [ "$CONFIG_ATARI" = "y" ]; then
   tristate 'Atari ACSI support' CONFIG_ATARI_ACSI
   if [ "$CONFIG_ATARI_ACSI" != "n" ]; then
      comment 'Some devices (e.g. CD jukebox) support multiple LUNs'
      bool '  Probe all LUNs on each ACSI device' CONFIG_ACSI_MULTI_LUN
      tristate '  Atari SLM laser printer support' CONFIG_ATARI_SLM
   fi
fi
tristate 'XT hard disk support' CONFIG_BLK_DEV_XD
dep_tristate 'Parallel port IDE device support' CONFIG_PARIDE $CONFIG_PARPORT
if [ "$CONFIG_PARIDE" = "y" -o "$CONFIG_PARIDE" = "m" ]; then
   source drivers/block/paride/Config.in
fi

if [ "$CONFIG_PCI" = "y" ]; then
   tristate 'Compaq SMART2 support' CONFIG_BLK_CPQ_DA
   tristate 'Mylex DAC960/DAC1100 PCI RAID Controller support' CONFIG_BLK_DEV_DAC960
fi

comment 'Additional Block Devices'

tristate 'Loopback device support' CONFIG_BLK_DEV_LOOP
if [ "$CONFIG_NET" = "y" ]; then
   tristate 'Network block device support' CONFIG_BLK_DEV_NBD
fi
bool 'Multiple devices driver support' CONFIG_BLK_DEV_MD
if [ "$CONFIG_BLK_DEV_MD" = "y" ]; then
   tristate '  Linear (append) mode' CONFIG_MD_LINEAR
   tristate '  RAID-0 (striping) mode' CONFIG_MD_STRIPED
#   tristate '  RAID-1 (mirroring) mode' CONFIG_MD_MIRRORING
#   tristate '  RAID-4/RAID-5 mode' CONFIG_MD_RAID5
fi
#if [ "$CONFIG_MD_LINEAR" = "y" -o "$CONFIG_MD_STRIPED" = "y" ]; then
#   bool '    Boot support (linear, striped)' CONFIG_MD_BOOT
#fi
tristate 'RAM disk support' CONFIG_BLK_DEV_RAM
if [ "$CONFIG_BLK_DEV_RAM" = "y" ]; then
   bool '  Initial RAM disk (initrd) support' CONFIG_BLK_DEV_INITRD
fi

endmenu