/* mc146818rtc.h - register definitions for the Real-Time-Clock / CMOS RAM * Copyright Torsten Duwe 1993 * derived from Data Sheet, Copyright Motorola 1984 (!). * It was written to be part of the Linux operating system. */ /* permission is hereby granted to copy, modify and redistribute this code * in terms of the GNU Library General Public License, Version 2 or later, * at your option. */ #ifndef _MC146818RTC_H #define _MC146818RTC_H #include /********************************************************************** * register summary **********************************************************************/ #define RTC_SECONDS 0 #define RTC_SECONDS_ALARM 1 #define RTC_MINUTES 2 #define RTC_MINUTES_ALARM 3 #define RTC_HOURS 4 #define RTC_HOURS_ALARM 5 /* RTC_*_alarm is always true if 2 MSBs are set */ # define RTC_ALARM_DONT_CARE 0xC0 #define RTC_DAY_OF_WEEK 6 #define RTC_DAY_OF_MONTH 7 #define RTC_MONTH 8 #define RTC_YEAR 9 /* control registers - Moto names */ #define RTC_REG_A 10 #define RTC_REG_B 11 #define RTC_REG_C 12 #define RTC_REG_D 13 /********************************************************************** * register details **********************************************************************/ #define RTC_FREQ_SELECT RTC_REG_A /* update-in-progress - set to "1" 244 microsecs before RTC goes off the bus, * reset after update (may take 1.984ms @ 32768Hz RefClock) is complete, * totalling to a max high interval of 2.228 ms. */ # define RTC_UIP 0x80 # define RTC_DIV_CTL 0x70 /* divider control: refclock values 4.194 / 1.049 MHz / 32.768 kHz */ # define RTC_REF_CLCK_4MHZ 0x00 # define RTC_REF_CLCK_1MHZ 0x10 # define RTC_REF_CLCK_32KHZ 0x20 /* 2 values for divider stage reset, others for "testing purposes only" */ # define RTC_DIV_RESET1 0x60 # define RTC_DIV_RESET2 0x70 /* Periodic intr. / Square wave rate select. 0=none, 1=32.8kHz,... 15=2Hz */ # define RTC_RATE_SELECT 0x0F /**********************************************************************/ #define RTC_CONTROL RTC_REG_B # define RTC_SET 0x80 /* disable updates for clock setting */ # define RTC_PIE 0x40 /* periodic interrupt enable */ # define RTC_AIE 0x20 /* alarm interrupt enable */ # define RTC_UIE 0x10 /* update-finished interrupt enable */ # define RTC_SQWE 0x08 /* enable square-wave output */ # define RTC_DM_BINARY 0x04 /* all time/date values are BCD if clear */ # define RTC_24H 0x02 /* 24 hour mode - else hours bit 7 means pm */ # define RTC_DST_EN 0x01 /* auto switch DST - works f. USA only */ /**********************************************************************/ #define RTC_INTR_FLAGS RTC_REG_C /* caution - cleared by read */ # define RTC_IRQF 0x80 /* any of the following 3 is active */ # define RTC_PF 0x40 # define RTC_AF 0x20 # define RTC_UF 0x10 /**********************************************************************/ #define RTC_VALID RTC_REG_D # define RTC_VRT 0x80 /* valid RAM and time */ /**********************************************************************/ /* example: !(CMOS_READ(RTC_CONTROL) & RTC_DM_BINARY) * determines if the following two #defines are needed */ #ifndef BCD_TO_BIN #define BCD_TO_BIN(val) ((val)=((val)&15) + ((val)>>4)*10) #endif #ifndef BIN_TO_BCD #define BIN_TO_BCD(val) ((val)=(((val)/10)<<4) + (val)%10) #endif /* * The struct used to pass data via the following ioctl. Similar to the * struct tm in , but it needs to be here so that the kernel * source is self contained, allowing cross-compiles, etc. etc. */ struct rtc_time { int tm_sec; int tm_min; int tm_hour; int tm_mday; int tm_mon; int tm_year; int tm_wday; int tm_yday; int tm_isdst; }; /* * ioctl calls that are permitted to the /dev/rtc interface, if * CONFIG_RTC was enabled. */ #define RTC_AIE_ON _IO('p', 0x01) /* Alarm int. enable on */ #define RTC_AIE_OFF _IO('p', 0x02) /* ... off */ #define RTC_UIE_ON _IO('p', 0x03) /* Update int. enable on */ #define RTC_UIE_OFF _IO('p', 0x04) /* ... off */ #define RTC_PIE_ON _IO('p', 0x05) /* Periodic int. enable on */ #define RTC_PIE_OFF _IO('p', 0x06) /* ... off */ #define RTC_ALM_SET _IOW('p', 0x07, struct rtc_time) /* Set alarm time */ #define RTC_ALM_READ _IOR('p', 0x08, struct rtc_time) /* Read alarm time */ #define RTC_RD_TIME _IOR('p', 0x09, struct rtc_time) /* Read RTC time */ #define RTC_SET_TIME _IOW('p', 0x0a, struct rtc_time) /* Set RTC time */ #define RTC_IRQP_READ _IOR('p', 0x0b, unsigned long) /* Read IRQ rate */ #define RTC_IRQP_SET _IOW('p', 0x0c, unsigned long) /* Set IRQ rate */ #endif /* _MC146818RTC_H */