blob: 435dba8eb0974a8f4e5234a54c0d651bef641354 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
|
#if defined(CONFIG_WAVELAN)
Thu Feb 23 00:10:31 EST 1995
1. At present the driver autoprobes for a WaveLAN card only at I/O address 0x390.
The version of the card that I use (NCR) supports four I/O addresses (selectable
via a pair of DIP switches). If you want the driver to autoprobe a different
subset of the four valid addresses then you will need to edit
.../drivers/net/wavelan.c (near line 714) and change the initialisation of the
`iobase[]' array. Normally, I use a LILO configuration file directive to
obviate the need for autoprobing entirely, a course of action I heartily
recommend.
2. By default, the driver uses the Network ID (NWID) stored in the card's Parameter
Storage Area (PSA). However, the PSA NWID can be overridden by a value passed
explicitly as the third numeric argument to LILO's "ether=" directive, either
at the LILO prompt at boot time or within LILO's configuration file.
For example, the following line from such a LILO configuration file would
auto-configure the IRQ value, set the I/O base to 0x390 and set the NWID to
0x4321, all on a WaveLAN card labelled "eth0":
..
append ="ether=0,0x390,0x4321,eth0"
..
3. If you encounter any problems send me some email.
Good luck,
Bruce Janson (bruce@cs.usyd.edu.au)
#endif /* defined(CONFIG_WAVELAN) */
|
