blob: 36055ae045cb52a2a2be4ab032adcd9559ac3dc5 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
|
mainmenu_option next_comment
comment 'Drivers for Etrax built-in interfaces'
bool 'Ethernet support' CONFIG_ETRAX_ETHERNET y
if [ "$CONFIG_ETRAX_ETHERNET" = "y" ]; then
# this is just so that the user does not have to go into the
# normal ethernet driver section just to enable ethernetworking
define_bool CONFIG_NET_ETHERNET y
fi
bool 'Serial-port support' CONFIG_ETRAX_SERIAL y
bool 'ATA/IDE support' CONFIG_ETRAX_IDE n
if [ "$CONFIG_ETRAX_IDE" = "y" ]; then
# here we should add the CONFIG_'s necessary to enable the basic
# general ide drivers so the common case does not need to go
# into that config submenu. enable disk and CD support. others
# need to go fiddle in the submenu..
define_bool CONFIG_IDE y
define_bool CONFIG_BLK_DEV_IDE y
define_bool CONFIG_BLK_DEV_IDEDISK y
define_bool CONFIG_BLK_DEV_IDECD y
define_bool CONFIG_BLK_DEV_IDEDMA y
define_bool CONFIG_DMA_NONPCI y
choice 'IDE reset pin' \
"Port_PB_Bit_7 CONFIG_ETRAX_IDE_PB7_RESET\
Port_G_Bit_27 CONFIG_ETRAX_IDE_G27_RESET\
Port_CSE1_Bit_16 CONFIG_ETRAX_IDE_CSE1_16_RESET" Port_PB_Bit_7
fi
bool 'Axis flash-map support' CONFIG_ETRAX_AXISFLASHMAP n
if [ "$CONFIG_ETRAX_AXISFLASHMAP" = "y" ]; then
# here we define the CONFIG_'s necessary to enable MTD support
# for the flash
define_bool CONFIG_MTD y
define_bool CONFIG_MTD_CFI y
define_bool CONFIG_MTD_CFI_INTELEXT n
define_bool CONFIG_MTD_CFI_AMDSTD y
define_bool CONFIG_MTD_CHAR y
fi
endmenu
|